Automated Polishing Machine
Send a request
CT-TS-POLA
Automated Polishing Machine
The Automated Polishing Machine LEAP250 polishes thin sections for petrographic analysis. A motorized sample holder arm carries one to four specimens on a 250 mm plate, and a variable-speed drive covers a range of polishing processes. The result is the polished surface finish of up to four sections prepared under the same conditions in one run.
How it works
Specimens are clamped in standard sample holders on the motorized arm, which rests them on the rotating plate. Load comes from 200 g weights, with four sets supplied, one for each holder position. The plate turns at a variable speed up to 600 rpm. Plate speed and cycle time are both adjustable, so a polishing sequence can be repeated from batch to batch. The drive runs without vibration at low speed, and the work area is accessible for cleaning between steps.
The four standard holders adapt to several specimen geometries: 30 × 45 mm, 1 × 1.5 in, 60 × 45 mm and 1 × 3 in.
Parameter Value Plate diameter 250 mm Plate speed Variable, up to 600 rpm Samples per run 1 to 4 Dimensions 526 × 589 × 380 mm Weight 50 kg Power supply 220 VAC, 50/60 Hz What is included
- Polishing unit with 250 mm plate and variable-speed drive
- Motorized sample holder arm for 1 to 4 samples
- 4 standard sample holders
- 4 sets of 200 g weights
Specify for your project
- Specimen size: 30 × 45 mm, 1 × 1.5 in, 60 × 45 mm or 1 × 3 in
- Number of samples per run, 1 to 4
- Polishing sequence: plate speed and cycle time for each step
- Sample material and required surface finish
- Site power: 220 VAC, 50/60 Hz
This description defines the product family. Guaranteed performance, included hardware, exclusions, interfaces and acceptance criteria are stated only in the project-specific technical proposal and approved datasheet.
Key data
- A plate of 250 mm diameter runs at an adjustable 10 to 600 RPM.
- Small specimens: 30x45mm (1 inch x 1.5 inch). Large specimens: 60 x 45mm (1 inch x 3 inch).
- The cabinet is 526 x 589 x 380 mm and weighs 50 kg.
- Mains: 220 VAC - 50/60 Hz.
Advantages
- There is no vibration at low speeds.
- Open access makes cleaning quick and easy.
- A motorized arm carries 1 to 4 samples, each with 4 sets of 200g weights.
- 4 standard sample holders adapt to different specimen shapes.
- Cycle time and plate speed can be adjusted.









