Benchtop Steady- and Unsteady-State Relative Permeameter
Send a request
CT-RCA-BSRP
Benchtop Steady- and Unsteady-State Relative Permeameter
One bench unit, two methods: the LESRP350 runs both steady-state and unsteady-state relative permeability tests on standard core plugs. Routine core analysis labs use it to produce oil-water and gas-oil relative permeability curves for waterflood and displacement studies, without moving the work to a full special core analysis rig. Liquid/liquid and liquid/gas pairs are tested at ambient temperature, with confining and pore pressure up to 350 bar (5,000 psi).
How it works
A plug of 1 in. or 1.5 in. diameter and 2 to 3 in. length goes into a hydrostatic core holder, where confining pressure acts on the sleeve from all sides. All wetted parts are stainless steel.
- Unsteady-state: one fluid displaces the other at a set injection rate, and relative permeability is derived from the production and pressure history.
- Steady-state: both fluids are injected together at set rates until flow stabilizes; the rate ratio is then stepped to trace the curve point by point.
The operator controls injection rates and confining pressure. The result is the relative permeability curve for the chosen fluid pair.
Specifications
Parameter Value Confining pressure 350 bar (5,000 psi) Pore pressure 350 bar (5,000 psi) Temperature ambient Core diameter 1 in. or 1.5 in. Core length 2 to 3 in. Loading hydrostatic Wetted material stainless steel N2 supply 2,000 psi Power 110 to 220 VAC, 50 or 60 Hz What is included
- Hydrostatic core holder for 1 in. or 1.5 in. plugs
- Confining pressure system rated 350 bar
- Pore pressure and injection system rated 350 bar
- Fluid separation, data acquisition and software as stated in the project datasheet
Specify for your project
- Plug diameter and length
- Test modes (unsteady-state, steady-state or both) and fluid pairs
- Confining and pore pressure, up to 350 bar
- Injection rate range and number of injection lines
- Effluent measurement and data acquisition
- Supply voltage and nitrogen at 2,000 psi
This description defines the product family. Guaranteed performance, included hardware, exclusions, interfaces and acceptance criteria are stated only in the project-specific technical proposal and approved datasheet.
Features
- Confining pressure: 350 bar (5,000psi)
- Pore pressure: 350 bar (5,000psi)
- Temperature : ambient
- Core diameter: 1" or 1''1/2
- Core length: 2'' to 3''
- Loading type: Hydrostatic
- Wetted material: stainless steel
- N2: 2,000 psi
- Power: 110-220 VAC, 50 or 60 Hz




