Windows for Stirred Reactors
Send a request
Windows for Stirred Reactors
Windows provide visual access, light transmission and other optical functions in stirred reactors and pressure vessels. They are commonly fitted in pairs: light enters through one window and the contents are viewed through the other.
Fused silica is the standard window material. Sapphire is also available for small diameters. Alternative materials can be selected for particular transmission requirements, with coatings on request. Several mounting arrangements are available.
This description defines the product family. Guaranteed performance, included hardware, exclusions, interfaces and acceptance criteria are stated only in the project-specific technical proposal and approved datasheet.
Threaded circular viewing windows
The basic screw-in window provides a 1/2″ diameter viewing area. A sealed window fitting mounts through a standard 1/2″ NPT male pipe thread. The vessel wall must be thick enough for the thread to engage fully. Depending on the O-ring material, an O-ring seal limits operation to 225 °C or below. A flexible graphite gasket option raises the temperature rating to 350°C. Window material and thickness determine the pressure rating, which ranges from 1900 to 5000 psi. The viewing area is small for direct observation, but it suits compact video systems and the passage of laser or other analytical beams. This mounting arrangement leaves a dead space of approximately 1.25″ between the inner window face and the vessel's inside wall.
Windows integrated into the vessel wall
Integral window arrangements place the inner face of the window close to the vessel's internal wall. This avoids the large dead space left by the screw-in design. Two standard shapes are available, as described below. The cylinder size determines the largest window that can be fitted.
The standard round window has a 1/2″ diameter viewing area. Several window materials are available, including sapphire for very high pressures up to 5000 psi. The round design accepts either an O-ring or a flexible graphite seal. Typical duties include direct visual observation, photography and optical sensor measurements.
The standard oblong viewing area measures 3.50” in length and 0.62” in width. Its use on a given vessel size is confirmed on request. This shape uses O-ring seals only. Fused Silica and sapphire are available, with a maximum rating of 1900 psi @ 225°C when FKM or FFKM seals are fitted. Oblong windows allow observation of both vapor and liquid phases and can show the liquid level. Larger vessels can carry several windows stacked vertically.
Standard round and oblong windows are available as replacement items. Larger custom versions of either shape can be supplied on request.
Reactors and pressure vessels with windows require heaters and supports tailored to the window configuration. The most common heating arrangements are flexible heating mantles, integral cartridge heaters and attached circulating jackets. The circulating jacket option applies to 600mL mini vessels and larger sizes.
Larger windows with external welds or flanges
Large circular windows can be mounted by an external weld or a flange connection to the vessel. Depending on vessel size and the selected window size, the viewing area ranges from 1 3/4″ to 7 1/4″. An externally welded window substantially lowers the vessel's maximum working pressure to 600 psi or less. Custom configurations with higher pressure ratings are also available.
Code and directive review on request
Design to pressure vessel codes and directives, including the code treatment of the windows, is available on request after project review.



















