High Pressure Straight Needle Valve
Send a request
High Pressure Straight Needle Valve
The LEHPSNV is a straight-pattern needle valve for high pressure lines. Inlet and outlet sit on one axis, so the valve installs inline and takes little space in a compact test rig or panel. It meters and shuts off gas or liquid flow. Laboratory operators use it to set fine gas or liquid rates and to hold pressure during a test. Stainless construction suits brine, gas and solvent service.
How it works
Turning the handle moves a long tapered stem toward or away from the seat. Because the taper is gradual, a turn of the handle changes the open flow area only a little, which gives fine control at low flow rates. Closed fully, the stem tip seats and shuts off the line. The straight pattern keeps the flow path in line with the tube run, so the valve can be placed directly in a line between two fittings without changing the direction of the tubing.
Use in a test setup
Typical positions are on a gas supply line, where the valve trims the feed rate, on a vent or sampling line, where it releases pressure slowly, and as an isolation valve between a pump or cylinder and a pressure vessel.
Pressure and temperature ratings, connection sizes, stainless steel grade and flow coefficient (Cv) are provided on request for the selected valve configuration.
Specify for your project
- Fluid: brine, gas, solvent or other
- Maximum working pressure and temperature
- Tube or pipe connection type and size
- Stainless steel grade and stem tip material
- Required flow range
- Inline or panel mounting
This description defines the product family. Guaranteed performance, included hardware, exclusions, interfaces and acceptance criteria are stated only in the project-specific technical proposal and approved datasheet.















