Gage Block Assemblies for Non-Stirred Pressure Vessels
Send a request
Gage Block Assemblies for Non-Stirred Pressure Vessels
LEGBA Gage Block Assemblies group the following functions for non-stirred pressure vessels:
- A valve for gas inlet and outlet.
- A gage for pressure indication.
- A safety rupture disc for pressure relief.
The compact block connects by tube to a small vessel head where fitting space is restricted. A threaded socket accepts a gas hose or tube with a type “A” coned pressure fitting. Coned fittings also join the thick-walled connecting tube between the block and vessel.
The valve regulates gas entering the vessel. With the valve closed, the gage indicates vessel pressure. The block contains a rupture disc whose burst rating is matched to the gage.
For vessels with a 1-inch I.D. and room for only one head port, an assembly version incorporates a 1/16″ O.D. thermocouple.
This description defines the product family. Guaranteed performance, included hardware, exclusions, interfaces and acceptance criteria are stated only in the project-specific technical proposal and approved datasheet.
Gage Block Assembly Sizes
The two gage block configurations differ only in pressure gage size and in the tube connection to the pressure vessel. The smaller assembly normally has a 3-1/2 inch diameter gage. Its 3 inch connecting tube ends in a type “A” coned fitting. This arrangement is normally used on pressure vessels with capacities up to 600 mL.
The larger assembly uses a 4-1/2 inch diameter pressure gage. A type “B” coned fitting connects its 3-inch long tube to the vessel. This assembly is normally selected for vessels with volumes of 1000 mL and above.
For both configurations, type 316 Stainless Steel is the standard material for the block, connecting tube and gage. Alloy 400 construction is available on request for these components. Connecting tubes longer than the standard length can also be supplied on request.
Assembly Selection Assembly Type Connection Description Smaller gage block assembly Fitted with a Type ‘A’ connector Larger gage block assembly Fitted with a Type ‘B’ connector Pressure Gage Choices
Either block assembly can accept any of the gages listed below. The table retains the available pressure ranges and the availability of each dial size for those ranges.
Pressure Vessel Gage Selection Measuring Range 4-1/2″ Diameter 3-1/2″ Diameter psi bar Gage Type Gage Type 0-100 0-7 Pressure gage Pressure gage 0-200 0-14 Pressure gage Pressure gage 0-600 0-40 Pressure gage Pressure gage 0-1000 0-69 Pressure gage Pressure gage 0-2000 0-138 Pressure gage Pressure gage 0-3000 0-207 Pressure gage Pressure gage 0-5000 0-345 Pressure gage Pressure gage 0-7500 0-517 Pressure gage NA 0-10000 0-690 Pressure gage NA Specify the required assembly type, pressure gage diameter and pressure range when ordering.









